Canals

Sailing the Limfjord: Passage, Bridge Opening Times and Harbours

By Redaktion toernfinder.de · Updated 16.11.2026 · 7 min read
Sailing Areas & HarboursSailing boat flying a Danish flag on the calm waters of the Limfjord

This page was translated automatically from German. View the original

Sailing the Limfjord means taking a sheltered waterway right across North Jutland, from Thyborøn on the North Sea to Hals on the Kattegat. From Thyborøn to Aalborg it is about 75 nm rather than about 170 nm around Skagen, but there are four to five bascule bridges along the way (as at: November 2026).

The essentials at a glance

  • The fjord is about 180 km long. The Thyborøn Kanal leads in from the west, and from the east the dredged channel across the Hals Barre, the sandbank off the mouth into the Kattegat.
  • The fairway is designed for a depth of about 4 m. Pilotage in the dredged channels is compulsory only for a draught of more than 3.1 m.
  • Bridges you must pass: Oddesundbroen, Aggersundbroen and the two bridges in Aalborg. Depending on your route around Mors, the Vilsundbroen is added.
  • Leisure boats are given openings at fixed times, once or twice an hour depending on the bridge, and at the railway bridge in Aalborg by arrangement. If you can lower your mast, you have no right to an opening.
  • Tides play hardly any role. Sustained westerly winds push water into the fjord, and westerly gales create a strong east-setting current.

What does the Limfjord passage from the North Sea to the Baltic Sea look like?

From Thyborøn you go through the Nissum Bredning to the Oddesund, around the island of Mors, then on via Løgstør and the Aggersund to Aalborg and through the Langerak to Hals. Bredning is the Danish word for the wide basins of the fjord; the Langerak is the narrow section east of Aalborg.

From Thyborøn into the Nissum Bredning, the buoyed Sælhundeholm Løb leads through the sandbanks with a depth of about 4 m.

West of Mors, the Vilsund with its bascule bridge leads into the Thisted Bredning and on through the Feggesund into the Løgstør Bredning. To the east, the Salling Sund leads past Nykøbing Mors, spanned by the fixed Sallingsundbroen with 26 m clearance. Both routes meet again off Løgstør.

In the western part the fjord is mostly only around 5 m deep. Only the Thisted Bredning and the channels in Vilsund, Salling Sund and Hvalpsund are deeper than 10 m. Between Løgstør and Aalborg depths are 5 to 9 m, and between Aalborg and Hals the 100 m wide fairway has about 10 m. All figures in nm are rounded, above water on the usual course; for precise planning, refer to the chart.

Thyborøn Kanal: How dangerous is the entrance in a westerly wind?

The danger lies in the weather, not in the entrance itself: the canal is about 1,000 m wide at the North Sea end, with no bridge or lock. There is a sand bar off the entrance.

Wind from the south-west to north-west often raises the water level at Thyborøn by up to 1.5 m. In calm weather the current runs at 1 to 2 kn and turns regularly. In a storm it reaches 4 to 5 kn and often runs in one direction for days. Sand migration constantly changes the depths off the harbour, so always use the latest chart.

Plan your approach from the North Sea for a calm weather window, not for strong onshore winds. The harbour entrance at Thyborøn faces east, and the current runs almost straight across it.

Limfjord Bridges: Opening Times and Rules for Leisure Craft

The bascule bridges open for leisure craft to a fixed schedule. The Danish Maritime Authority's full bridge regulations can be found in the official Danish harbour and bridge guide.

Bridge Location Clearance height when closed Openings for leisure craft
Oddesundbroen Gateway to Nissum Bredning 4,3 m once or twice an hour during the day according to the timetable, depending on train traffic
Vilsundbroen between Thy (the region west of Mors) and Mors approx. 3.75 m once an hour, twice an hour at weekends and in weeks 27 to 31
Aggersundbroen east of Løgstør approx. 5.4 m as for Vilsundbroen
Jernbanebroen Aalborg, western bridge approx. 3.3 to 4.4 m by arrangement with the bridge keeper, depending on train traffic
Limfjordsbroen Aalborg, eastern bridge 9,5 m once an hour on the hour, with closures during rush hour

How do you contact a bridge?

You call up on VHF channel 16 (at the Oddesundbroen also channel 12) or use the signal: by day, flag N hoisted half-way and one long and one short blast; at night, a white light at the bow and the same sound signal. At Oddesund, Vilsund and Aggersund, give the signal at least 0.5 nm before the bridge; at the two Aalborg bridges, at least 600 m before.

The bridge responds with red lights: one steady red light means passage prohibited, two apply to vessels coming from the east (at Vilsund from the north), and three to vessels coming from the west (at Vilsund from the south). If the lights flash, the bridge is opening; if they are steady, the passage is clear.

Distance, Speed and Engine

Until the passage signal comes, stay at least 200 m away from the Oddesundbroen. At the Limfjordsbroen, wait 100 to 400 m before the bridge. Near all bridges, go only as fast as you need for steering. At Oddesund and at the Limfjordsbroen, you must have the engine running when passing through. The bridges open up to a mean wind speed of 18 m/s, and the Oddesundbroen up to 20 m/s.

Special features at Vilsund, Aggersund and in Aalborg

The Vilsund and Aggersund bridges are closed to pleasure craft on weekdays outside July during the morning and afternoon rush hours. Their operating times vary with the month: longest from May to July (6 am to 10 pm), shortest in December and January (8 am to 4 pm).

For passage at the railway bridge in Aalborg, arrange it with the bridge keeper in advance if possible, via VHF channel 16. The exact minutes at the Oddesundbroen can be found in the bridge keeper's opening timetable.

Current and water level: what is different in the Limfjord?

In the fjord, the wind determines the water level, not the tide. The tidal range runs from under 5 cm in the Salling Sund through about 0.3 m in Aalborg and Hals to about 0.5 m in Thyborøn.

Sustained westerly winds push water in, and in the Salling Sund high water of up to 1.6 m is possible, and 1.3 to 1.5 m in Aalborg. Easterly winds empty the fjord, by up to 1.5 m below normal in the Salling Sund. Westerly gales create a strong east-setting current.

At Oddesund the current can run hard and not always in the direction of passage. For this reason, approach the bridge at right angles if possible.

Limfjord harbours: where to moor along the way

Important harbours along the way are Thyborøn, Thisted or Nykøbing Mors, Løgstør and Aalborg.

Thyborøn

Fishing and industrial harbour on the channel. Pleasure craft may moor in the Nordre Inderhavn only in the summer half-year, and at other quays only with permission from the harbour watch.

Thisted

Harbour on the Thisted Bredning with a marina, workshop and crane, on the western route around Mors.

Nykøbing Mors

Main town of Mors on the Salling Sund. A dredged channel with a depth of 4.5 m and leading lights takes you in, and there is shore power, water and diesel. A maximum of 3 kn applies in the marina.

Løgstør

Mussel town before the Aggersund, with mussel festivals in summer. This is where the channel across the Løgstør Grunde begins, with its leading line. Pleasure craft moor in the canal harbour on the Frederik VII Canal of 1861, which used to bypass the shallows. The Limfjordsmuseum stands on the canal.

Aalborg

The largest town on the fjord, with several marinas. The Vestre Bådehavn lies west of the two bridges and takes pleasure craft with a draught of up to 2.3 m.

Sailing the Limfjord: what makes the sailing area special?

The Limfjord alternates between wide basins and narrow sounds. Mors is the largest island, joined by Fur, Venø, Livø and Egholm. The seals lie at the protected, inaccessible Livø Tap, a spit of land on the island of Livø. Oysters used to be fished here, but today only mussels are.

When is the best time for the Limfjord?

From May to August you have the longest bridge times and the most openings. In weeks 27 to 31, Vilsund and Aggersund also open twice an hour on weekdays.

The opening schedule of the Oddesundbroen applies from Maundy Thursday until the end of the Danish autumn holidays.

Keep planning on Törnfinder

You will find sailing trips on Törnfinder in Denmark, on the Baltic Sea and, if you are arriving from the west, on the North Sea.

Frequently asked questions

How long does the Limfjord passage take?

Allow several days: around 75 nm to Aalborg, plus the Langerak as far as Hals and waiting time at the bridges.

Do I have to register in advance to pass the bridges in the Limfjord?

No. You call up on the spot by signal or on VHF channel 16 and pass through at the next scheduled opening. Only at the railway bridge in Aalborg should you arrange your passage in advance where possible.

How deep is the Limfjord for sailing yachts?

The channel is designed for a depth of around 4 m, which is enough for typical cruising yachts. Due to shifting sand, depths may differ in places.

Can I pass through the Limfjord bridges at night?

Only to a limited extent. The Oddesundbroen is manned around the clock and opens on demand outside its daily schedule. At Vilsundbroen and Aggersundbroen you can request an opening outside operating hours if you arrange it during operating hours. The Limfjordsbroen opens for pleasure craft only within its operating hours.

Share this post

More from Sailing Areas & Harbours

All 268 articles →